← BACK TO BLOG

How Do I Turn Spoken Words Into Binary ASCII Art?

Open BeamTracer Performer, choose CHARACTERS → BINARY in ASCII, and turn on SPEECH TO BINARY. The effect spells the words it hears in binary. Bright parts of the picture give the digits somewhere to show up.

The demo feeds fixed sample phrases to the effect over TRINA · HANDS. On your device, the browser supplies the words from your microphone.

How do I get the same binary look in Performer?

Start with TRINA · HANDS so you have a bright shirt and moving hands to check. Use PICTURE to place the digits and BINARY to enable the speech switch.

  1. Choose TRINA · HANDS in FX RACK → SOURCE and leave the clip playing.
  2. Open ASCII in the rack and select FIELD → PICTURE.
  3. Set CHARACTERS → BINARY to reveal the speech controls.
  4. Match the values below. Use the MIX slider inside ASCII.
  5. Turn on SPEECH TO BINARY and allow microphone access when prompted.
  6. Say a short phrase and look for it under HEARD before tuning the look.
ControlDemo setting
CELL SIZE18 px
MIX0.83
TONE → BRIGHTNESS0.19
BACKDROP OPACITY0.45

Leave the other ASCII values at the settings loaded by the link. At this mix, the face and hands are visible between patches of digits. With a different camera or logo, start here and adjust cell size or brightness against the same part of the picture.

How do I tell whether the digits are responding to speech?

Pause for a beat between two short phrases. First, read HEARD. Then look at the digits in a large, bright patch of the image, such as the shirt. The source can keep moving while the same message repeats. Check HEARD for the new words.

Next, click CLEAR HEARD and speak again. The message starts over while listening continues. To see why one phrase looks different from another, an uppercase A received from the browser is the UTF-8 byte 01000001. The effect lays the bits out left to right, then top to bottom, and repeats them. The image determines which positions are lit, so some of those eight positions may fall on dark cells and stay invisible.

For the visual check, shrink the preview to the size you expect people to see. You should still be able to tell a zero from a one and recognize a hand or face at a glance. If you can only make out the subject when you enlarge the player, adjust the mix or cell size before recording.

Can I use a logo instead of a video?

Choose SOURCE → VIDEO · IMAGE and upload a light logo on a dark background. Leave FIELD on PICTURE. Start with the table settings, then test the narrowest stroke in the logo. If it breaks up, try CELL SIZE 14 px as a comparison and look at that same stroke again. Switch back to 18 px if the smaller digits are hard to read at the size you plan to share. Try increasing the light area of the source graphic if the stroke still disappears.

Why are my words or digits missing?

What you seeWhat to check
The switch is missingSelect BINARY under CHARACTERS. PICTURE is a separate field setting.
HEARD stays emptyCheck the browser’s microphone permission and selected input. Confirm the mic works, then toggle listening off and on and try one short phrase.
HEARD updates, but the digits are hard to seeSwitch to the bright shirt in TRINA · HANDS or a light-on-dark logo. Check that the rack and ASCII are enabled and raise BRIGHTNESS a little at a time.
The face is hard to recognizeLower the MIX slider inside ASCII and recheck at output size. Stop when you can read the digits and recognize the pose.

Turn off SPEECH TO BINARY when you finish. The browser runs speech recognition and may send microphone audio to its speech service. For a readable transcript on screen, use the Speech visualizer. For falling code over a camera or logo, see the Matrix Rain tutorial and the ASCII controls.

Get BeamTracer updates by email

Email me

At most one email a day and three a week across both. No spam. Unsubscribe anytime.

We email a link to confirm first. Every email has an unsubscribe link. See our Privacy Policy.