How Do I Align Laser Graphics and Video on a Curved Wall?
Use the GRID in BeamTracer Video to Laser → LIVE to see the same alignment pattern on the video and laser routes. Fit the outside with four corners, then use Mesh warp where the surface bends. Save the video and laser adjustments under one VENUE SETUP to recall them together the next time you use the room.
Software preview. Moving a mesh point bends the grid inside the outer frame.
When should I use Corner Pin or Mesh warp?
Use four corners for the outline of a flat panel viewed from an angle. If the corners fit but the cells inside still drift away from your reference, use a mesh to correct the interior. Start with 2 × 2, which has nine points. Move to 3 × 3 when you need an extra row or column of handles.
- Open Video to Laser → LIVE and select NOT A MOON for a software rehearsal.
- Turn on GRID under SOURCE + TRACE.
- Open PROJECTOR SETUP. Check for LASERS STOPPED · GLOBAL BLACKOUT ACTIVE.
- Choose MOVE CORNERS to adjust the outside of the video frame.
- Set Mesh warp to 2 × 2 · 9 points, choose MOVE MESH POINTS, then move the center point a short distance. Use Point X and Point Y to make precise adjustments.
- For the laser’s separate controls, close the dialog and open PROPERTIES → LASER OUTPUT → Alignment + Safety Area. Use Corner Pin for the outside and Mesh warp for the interior.
- To make a pair of calibration files for an offline workflow, open ANIMATION STUDIO → Projection Mapping with a laser layer selected and enable ALSO EXPORT ALIGNMENT PAIR for an ILDA grid and its matching video.
With the corners fixed, watch the lines on both sides of the point you moved. If lines cross, back off the last move or use RESET MESH and try again. Use current Chrome or Edge for the projector mesh, which needs WebGPU. Look for a support message if the projector window stays flat while the editor grid bends.
How do I save the setup for the next visit?
Open LASER OUTPUT → VENUE SETUP, type a descriptive name such as Room A curved panel, and click SAVE AS. To bring it back, choose it under Setup in use. A recalled setup restores the corner and mesh settings in this browser. It stops laser output and does not start a device.
Look for CHANGED SINCE SAVE if you move a point after saving. Use UPDATE only when you want to keep that change. If the projector or mount has moved since the last show, check the grid again before relying on the saved coordinates.
What should I check in the preview?
Use 2D to check where paths sit in the frame. Switch to CINEMA to inspect how those same paths read in simulated haze. In haze, look at whether you can still pick out the main outline when the viewpoint changes.
The software rehearsal does not check physical alignment, scanner behavior, or audience exposure. Follow the laser safety guide and have a qualified operator verify the hardware and controlled projection area on site.
See the projector mesh controls and Animation Studio’s projection mapping export for the matching calibration files.