How Do I Preview a Laser Dot Chase Before a Show?
BeamTracer’s free browser preview lets you compare laser cues without connecting a projector. Open Dot Cross Beat in ILDA VIEWER at 30 fps. Use 2D to check the chase direction, switch to 3D to see the simulated beams, and read the point load before you choose a download.
Dot Cross Beat at 120 BPM, shown in the ILDA Viewer's Cinema simulation.
What should I look for in a dot chase?
Pick a movement that reads quickly. Dot Scan Rows Down · Cyan gives you a horizontal row that sweeps down the field. Dot Cross Beat · Cyan and Magenta alternates two expanding diagonals. If you want the effect to pull the eye toward the middle, start with the cross. If you want to follow one movement across the whole field, start with the row.
Rows Down runs for 144 frames, or 4.8 seconds at 30 fps. That gives the straight sweep more time to cover the field than the two-second cross. Preview each cue in 2D at least twice. Watch an individual dot for direction, then look at the whole group to see when the movement changes. Pause on one cyan accent and one magenta accent. When you press Play, use those colors to track the change of direction.
Rows Down in the 2D viewer. Follow the row from top to bottom, then watch where it starts again.
How do I inspect the loop one frame at a time?
Load the 120 BPM cross in the viewer for a short comparison. The file contains 60 frames, which is 2 seconds at 30 fps, or one bar of four beats at 120 BPM.
- Select OPEN IN ILDA VIEWER on the cue page.
- Select 2D and open PLAYBACK CONTROLS.
- Set FPS to 30 fps and Beat Sync to Off - Loop Freely for this check.
- Pause the cue and move the frame slider through the first 15 frames. At 120 BPM that span is one beat long. Repeat around the end of the file and watch what the dots do as the loop starts again.
- Press Play to check the same sequence at its intended speed.
- Return to the cue page to download the .ild file once you've picked your look.
The simpler 2D view makes it easier to see which dots move together.
If the two diagonals look like one constant cross, pause on a few different frames. If the switch is clear when paused but blends during playback, try a longer sweep such as Rows Down. If you see more travel than you want, compare both cues in the same preview mode before changing the venue lighting or the beam look. When you need the cross to match another track, choose the corresponding file under Other tempos. The 128 BPM version is 225 frames at 30 fps, which covers four bars. Check a complete loop before you decide where to bring it in.
How do I check the beam view?
Select 3D. Under SCENE → BEAM MODE, choose Cinema — Premium fog. Studio includes the unwatermarked view. Select Orbit Mode from the camera menu. For the Cinema example above, ATMOSPHERE uses FOG 0.50, SMOKE 0.60, and CONE 0.25. Watch the cue from the side to see whether the accents remain distinct in simulated haze. If the beams pull your eye away from the pattern, lower ATMOSPHERE → CONE and check whether the individual rays separate. Switch back to 2D to confirm which part of the design is present in the file. To compare without Cinema, use BEAMS on the library cue page.
The cue page lists its heaviest frame as 456 points, about 13.7 kpps at 30 fps. For physical projection, see the laser safety guide. The ILDA Viewer guide explains the inspection controls. See library preview options for the controls on each cue page. The cue is free to preview. The download requires Pro with Laser, Bundle, or Studio.