← BACK TO BLOG

How Do I Draw a Ring of Shapes With One Oscilloscope Signal?

In BeamTracer’s OSC-1, open CREATOR → SHAPE TOOLS → SHAPE MORPH and start a circle. Set Copies to 4 and Layout to Ring. One stereo XY signal keeps all four circles in step. You can change the spacing of the entire ring with Spread and use the redraw-rate readout to spot flicker before recording.

How do I place four copies around a ring?

Start with VECTOR DISPLAY so the connections between positions stay out of the way. Keep the initial shape simple so you can spot when the four drawings overlap.

  1. Open OSC-1, choose CREATOR and select VECTOR DISPLAY under SCOPE PRESETS.
  2. Under SOURCES → SHAPE TOOLS → SHAPE MORPH, choose Circle as SOURCE.
  3. Leave Progress at 0% and press START at the bottom of SHAPE MORPH.
  4. Raise Copies to 4. Choose Ring from Layout.
  5. Set Spread to 0.60 and Speed to 1.60. Confirm Display reads ALL.
  6. Open EXPORT → VIDEO and choose RECORD LIVE INPUT to save the performance as WebM. See the export guide for the available recordings.

At Speed 1.60, the trace rate is 160 Hz. Four copies divide that into 40 Hz each, as shown beside the count. Compare that with Speed 1.00, where each circle gets 25 Hz. The app flags rates below about 30 Hz. Three copies at Speed 1.00 give each position about 33 Hz. Try that if you prefer the slower base speed.

The Shape Tools example changes count, placement, and spread. Compare it with the ring in the opening clip.

How do I move one shape around the ring?

Click ALL next to Display to switch to FOCUS. Set Crossfade to 1.00, then sweep Focus from copy 1 toward copy 4. Watch the trace move through the spaces between its resting positions. Try the same sweep with Crossfade 0.00 to make each handoff a hard switch. All four positions still belong to the layout. FOCUS draws the selected position at the full trace rate, so the rate rises when you switch from ALL. Stop between two positions to see what Crossfade does, then return to ALL to compare the four-circle figure. Map Focus to MIDI or OSC if you want to perform the movement without dragging the slider.

How do I fix flicker or connecting lines?

Check the readout first when the shapes seem to blink. Add speed or remove a copy and compare the same layout. If the outlines overlap even at a steady redraw rate, increase Spread a little. The copies shrink as they move apart. If the circles bunch up after you change Layout, reset Spread to 0.60 before comparing Grid with Ring.

A stereo XY file still carries the motion of the beam between copies. VECTOR DISPLAY and AMBER CRT hide those connector spans in OSC-1. If an external display shows them, try fewer copies or bring them closer to shorten the travel. Keep both stereo channels intact when moving XY audio between apps.

See Shape Tools for all placement options and the drawing travel tutorial for a closer look at how a trace moves between objects.

Get BeamTracer updates by email

Email me

At most one email a day and three a week across both. No spam. Unsubscribe anytime.

We email a link to confirm first. Every email has an unsubscribe link. See our Privacy Policy.