How Do I Draw My Face and Hands on an Oscilloscope?
In OSC-1, open CREATOR → SOURCES → VIDEO SOURCE, choose CAMERA, set the TRACE row to SKELETON, and click DISPLAY. Start with a slow turn of your wrist and watch whether the finger lines follow it.
The example switches from EDGES to SKELETON on the same prerecorded camera feed.
How do I set up a clean Skeleton trace?
Frame your face and both open hands, then switch from EDGES to SKELETON on the same feed. The direct comparison makes it easier to see which lines follow the person.
- Open CREATOR, then SOURCES → VIDEO SOURCE. Choose CAMERA and allow camera access. If you have an old crop or trace setting, RESET VIDEO clears your settings and stops capture. Choose CAMERA again to reconnect.
- Press RAW in the preview controls and frame your head and shoulders. Hold both hands up beside your face with enough room to open your fingers. Leave space at the sides for your widest gesture. Use light from in front so you can still see your eyes and fingertips in the raw image.
- Press the TRACE preview button beside RAW and EDGE MAP.
- Choose EDGES in the separate TRACE row. Use the reset edge settings of Edge Threshold 15%, Detail Level HIGH (1.0), and Smoothness OFF. Leave REMOVE BG off and use no crop MASK.
- Click DISPLAY and confirm it reads DISPLAYING.
- Choose SKELETON in the TRACE row. Hold both palms still with your fingers separated while the detector starts. Look for a face outline and arm connections as well as fingers.
The setup clip shows where the TRACE options and DISPLAY button are. Use the opening clip to compare the switch to SKELETON.
How do I know the trace is working?
Start on a still pose. Look for both wrists, separated fingers, and a recognizable face outline. Then open and close one hand while the other stays still. Check whether the fingers open in the trace while the other hand stays in place. Repeat with a slow turn of the wrist. Hair and shirt detail should fall away when SKELETON is selected because it draws landmarks from the person.
Watch the full gesture at the size you intend to show it. If a fingertip drops out only at the edge of the frame, widen the shot and repeat the same move before changing another setting. If the hand stays in shot but the fingers overlap, turn the palm toward the camera and separate them to see if the lines come back.
Why are lines missing or flickering?
| What you see | What to try |
|---|---|
| No camera image | Check browser camera permission and use RAW to confirm you have the intended feed. |
| RAW works, but the scope is blank | Check DISPLAYING. With SKELETON selected, give it a well-lit face and an open hand to find. Check for an old crop MASK if the trace cuts off at the same spot. |
| The face works, but a hand breaks up | Keep the full hand visible. Move it away from your face, slow the gesture, and repeat it with your palm toward the camera. Check the changed framing in RAW. |
| The room or clothes keep showing up | Check that SKELETON is selected in the trace row. If you want the person’s outer silhouette, use EDGES and try REMOVE BG. |
Smoothness is for EDGES and CENTER LINE. It disappears in Skeleton mode, so use framing and a clear view of the features to get a steadier pose. For a graphic made of drawn strokes, try CENTER LINE to follow the middle of each stroke. Start with the same edge settings and use the TRACE preview to compare.
See the Video Source guide for the preview controls. If your source is a model, follow the 3D character outline tutorial.